New Vinyl Flooring Has Bubbles

Apply new glue and let it sit for a few minutes.

New vinyl flooring has bubbles.

Then use a towel and a hot iron to heat and flatten the vinyl. Press the needle completely through the vinyl to provide a means for trapped air to escape. You can simply remove the damaged vinyl tile and replace it with a new one instead of pricking the. Puncture the center of a flooring bubble that s less than an inch across using a sturdy sharp needle.

Here is the secret for removing bubbles in vinyl flooring. Wipe off any extra glue. They are long bubbles. Cut the bubble open and flatten the edges and trim any overlap around the cut.

Leave the books in place for a day or two to ensure that the vinyl rebonds with the surface below. Put a piece of cloth on top of the fix and then put a board on top of that. They are at least 12 15 long and about 6 8 wide. For small bubbles an inch or less in diameter use a large needle to prick the bubble allowing the trapped air to escape.

Use a stack of books to weight it down until it rebonds. As the vinyl cools it will retain its new flattened state. Press the edges down. For larger bubbles use a towel and iron.

After the time has passed remove the weight and clear away from the sheet vinyl flooring any excess adhesive that has come to the surface. Scrape off any glue from the floor under the edge with the old bubble. To give you more information about the flooring the flooring instructions say to install using a modified loose lay method and glue can be used over concrete and wood surfaces in indoor residential areas. To fix large vinyl flooring bubbles those larger than an inch in diameter try following these steps.